Contact Us

(+9821) 88-71-7011

 

Opening Times

Sat - Thu 10.00 - 19.00

Surface Protection Points

Surface Protection Points

When using adhesive surface protection products on a job site there's always a small risk of adhesive transfer. Improper set up, high temperatures, high traffic, and surpassing the really helpful 'remove by' date can all lead to problems with carpet masks and films. Following are a few suggestions to avoid any adhesive transfer.

Always observe the producer's suggestions when using carpet films. Carpet film utilization rankings range from 30 to 60 days. Leaving the film on carpets past the recommended utilization rating invalidates all manufacturers' warranty.
Use films made in the USA for the very best warranty protection and highest quality.
Carpet films use either water based or solvent based mostly adhesives. Water based mostly adhesives are simpler to remove if a problem occurs.
By no means set up adhesive carpet protection on wet or damp carpet.
Never set up adhesive carpet protection over glue down carpet for a minimum of 72 hours to allow the glue to "breathe".
If carpet has been installed over a newly poured cement slab that isn't totally cured, keep away from utilizing adhesive carpet protection as it can trap the cement moisture and discolor the carpet.
In cases of extreme heat, shorten the advisable time of application by 50%.
As acknowledged on the set up instructions of every film manufacturer, there is no such thing as a warranty offered for application on wool carpets.
If the above steps are taken, the prospect of any adhesive transfer when using a carpet film is negligible. Within the cases where steps have NOT been adopted, one in all these two points might happen: 1) sticky adhesive residue on carpet, or 2) discoloration of carpet where the plastic was used. It is vital at this step to know the type of adhesive used, water or solvent based.

Water based mostly adhesive film residue simply removes with warm water and might be quickly removed via steam cleaning the carpets. Solvent primarily based adhesive residue may additionally be removed by way of steam cleaning however it could take more than one cleaning to totally remove the adhesive. Citrus cleaners available at any hardware store can typically aid within the removal of solvent based mostly adhesive residue. If further problems persist, contact your local surface protection supplier to debate other potential solutions.

Discoloration of carpet is caused by the trapping of moisture under the film and the subsequent response of the moisture and the chemical compounds within the plastic film. Sadly this situation can only be remedied by removal of the affected space of carpet. This situation occurs most commonly in cases the place customers have carpeted over slabs that were not totally cured.

If you have any sort of inquiries concerning where and exactly how to use correx floor protection, you can call us at our own web-page.